FORScan forum

at the risk of beating a dead horse, its already been mentioned in this thread that it is critical to get an OEM camera for it to work well with the system.

apparently its also critical to get EXACTLY the same part number as I mentioned in my previous post, I got a camera that was almost exactly ...

apparently even ordering the correct FoMoCo part number may not be enough as I ordered a genuine ford part with the exact correct part number and it still doesn't work.

on closer inspection the part number of what I ordered and what was delivered was slightly different. the two letter Suffix of my ...

Ok So I switched back to my original camera and works fine other than the original scratch on lense that I was replacing it for
Upon further examination

Rather than part # JL1T-19G490-AB

They Shipped LL1Z-19G490-B

Looks like I need to find the correct part number.

I have a 2018 expedition with backup camera, ford OEM camera replaced and shows up fine as a backup camera, but doesn’t have the guide lines or show up in the 360 view.

I did as was suggested in a 2020 post

I'm running the FORScan V2.3.35 beta software.
On the left hand side of the App select the ...

Revive an old topic…

I have been able to access the as built codes for my 21 Miata, but unlike ford, there don’t seem to be many people trying to figure out what everything does, and as such there is an apparent absence of a spreadsheet showing available modifications

Anybody tried anything they ...

I will answer my own question a bit,

It’s not the 726-12, I think its the 726-44 that changes tire size

I had previously had about a 20% discrepancy in the circumference of the tires I was running and what was in the original as built coding.

This wasn’t enough to warrant calibration when the ...

Will changing tire size in the 726-12 block effect a change in the navigation or is there also a location to change it in the APIM module?

I figured there were some settings for some sort of dead reckoning.

Anybody know what line and spot those settings are in for the f250

I have upgraded to a sync 3 and have programmed with forscan to get climate control to work and everything else works except Nav

I have the Nav button, I can see the map but it's showing me anywhere from my actual location to start then as I drive it shows correct direction of travel but shows me ...