FORScan forum

I'm trying to upgrade the firmware on a sync3 unit that I have on the bench and I don't want to rip a car apart to attach it momentarily.

When I try to upgrade the firmware on it, I get an error that says:

-----
Hardware is not compatible
Hardware number stored in the vehicle profile is not ...

It's only three years later... but I was able to get this working and I actually didn't need any parts. Below are the changes I made, X's are locations I didn't change. I did confirm I had the HCU that supports ABS however. I never installed the HUD unit, so it's not necessary.

IPC
720-01-02: XXXX ...

I'm unable to see all options for the C-CM to be able to configure it. Has any one ran into this issue? Picture for reference.

I got my part from a 14 Taurus, but it should fit - DG1T-9G768-BA. I'm wondering if the C-CM shutsdown and won't allow configuration if it doesn't have communications with the HUD module as I didn't install that. I'm going to purchase that shortly and try it out.

Have you installed the HUD module ...

I've added a Cruise-Control Module to my 2014 Ford Explorer (has Sync 3). When I try to configure the cruise-control module using the as-built method, I don't see all the configuration field I'm expecting. I'm expecting to see 764-01-01,764-02-01 through 74-02-04. However, I only see 764-01-01 and ...