FORScan forum

Set up in connection settings

ISO15765 support : in application

If the battery monitoring sensor is removed from the battery negative post, all internal parameters except battery time in service reset to a standard setting. These parameters will be relearned during normal calibration intervals. If the battery has been charged or jump started by connecting ...

I noticed that when entering the SBL programming state (Updating another module) generally in the programming state, the BMS started to miscalculate the SOC. BCM RESET didn't help so I decided to do a BMS reset and it didn't help either. So I disconnected the battery from the car, then reset the BMS ...

Component Description

Battery Monitoring Sensor

NOTE: Unless the battery is being replaced, DO NOT reset the battery monitoring sensor using the scan tool. This reset is reserved for new battery installation. This reset clears the learned battery data, the battery time in service, and affects the ...

it is also important that after the battery is fully charged, do not put the car in standby mode for at least 3 hours after a full charge. so that BMS can easily dump the battery energy to 80% and calculate Soc. carry out calibrations in this way once every 3 months

Battery State of Charge

During the drive cycle the Electrical Energy Management software will adjust the initial battery state of charge by monitoring the
charge and discharge current and adjusting the state of charge up during charging, and down during discharge. During rest
periods (key off ...