Page 2 of 2

Re: Module firmware update, Error opening file

Posted: Sun Feb 26, 2023 10:32 pm
by tractmec
ZekeTheSneak wrote: Sat Feb 25, 2023 8:36 pm On the f150 forums it is described as pull drift and wander. There is a Ford investigation on the issue. I forget the official term when Ford is looking into something? I can provide some links to that. But no tsb has been issued as far as I can tell.

https://www.f150forum.com/f118/2015-201 ... er-336159/


The truck will pull slightly to one side and then correct and go the other way and basically wander down the road. It is not an alignment issue but a steering rack programming issue and/or epas issues. The center of the wheel feels dead. I have to move the wheel left or right to take up the slack. I have tried this with the "pull drift compensation" turned on and off multiple times. Multiple alignments. Inspected equipment and tryed replacing lower control arms. Also upgraded to the SPC camber caster adjusters.
Now: that comment about "Moving the wheel left or right to take up slack", I find interesting! Is that slack in the wheel when the system is off as in Engine is not running?

Re: Module firmware update, Error opening file

Posted: Sun Feb 26, 2023 11:42 pm
by ZekeTheSneak
When it's off it feels firm.

Re: Module firmware update, Error opening file

Posted: Thu Mar 02, 2023 9:28 am
by LaForge
To go back to topic:

You have not loaded the needed Files, thats all.
If you have a paid licence Forscan will load the Files.
With a free trial not.

Best regards

Karsten