FORScan forum

Hello everyone, I have a ford tourneo 1.8 tddi 2006 75cv, I am initializing the fip module
I follow the steps well, and then when it tells me that it needs 10 more minutes to erase the immobilizer remotely, it always gets the error
"The service procedure has been interrupted"

I am doing something wrong? I have tried to delete all the keys (there are two) and to add them, and it goes well, but then when reinitializing the FIP, I always get that error. Does anyone know something ? If you need more information, I can provide it, greeting.

Are you using the OBDLink EX FORScan OBD Adapter?

No, I am using the ELM327 ford, this same

that may be the problem?

That's likely to be your problem then. Buy OBDLink EX.

This do I need to buy?

i didn't know him thanks a lot !


https://es.aliexpress.com/item/40009955 ... hweb201603_

Good ! I am about to buy this obdlink EX on aliexpress.

Am I buying it from the correct site?

Is it valid to adapt the VP30 pump in the ford Tourneo 1.8 TDDI 75 hp year 2006?

I think I have a J1850 protocol, and I have a Visteon DPC 808 ecu.

Will it be used to adapt the scrapping pump?

https://es.aliexpress.com/item/40009955 ... hweb201603_

Today I received the ibdlink EX cable and I have not been successful. I have the same error again. The service procedure has been interrupted.


I am using windows xp, and forscan connects correctly. The obdlink EX drivers were installed successfully. That could be happening ?

I didn't know that OBDLink sold on aliexpress. Are you sure it's not a clone?

You should purchase OBDLink from OBDLink.

Yes, I bought it from the obdlink store. Is this correct?

Could the problem be that the vp30 pump is blocked?

The problem is solved! the problem was that the pump module did not have 12v power. And the programming of the country never started.

But now I have another problem . Once the adaptation is complete, it asks me to turn off the ignition, but it asks me again and again. What can be ?