FORScan forum

Hello everyone
So I have a 2015 Ford Fiesta Europe version
and I just want to know is it possible to activate the needle sweep when switching the ignition on as it's not available in ' Configuration and Programming IPC Module ' ?
The needles controllers are already there, I performed the sweep using PID Reading
Long story short :



is it doable to set FGPP,SPPP and TPP values to 100 % when switching the ignition on and then back to 0 % ?
Thanks in advance.

from what i've read online it isn't possible. I've been trying to do the same with my 2015 Focus ST with no luck.

arduino... enjoy

I've heard a bit about arduino but mostly on RC forums, how exactly does it work on Fords?