Page 1 of 1
service procedure has been interrupted
Posted: Sat Nov 13, 2021 7:36 pm
by M.R.F.O.R.D
I have a 2021 F150. When I try to run the PCM Module relearn I get a message service procedure has been interrupted (change the tires size). I was told on a few forums that there's a new version that fixes this issue?
Re: service procedure has been interrupted
Posted: Mon Nov 15, 2021 5:59 pm
by Exo_Strike
I have the same issue on 2021 Navigator and 2021 Bronco.
I dont tried the last build on F150 2021, but i know a earlier test build (FORScanSetup2.3.40.test20210322) works on F150 2021, i did it before.
Re: service procedure has been interrupted
Posted: Tue Nov 23, 2021 3:11 am
by cwkd9
I had the same issue and had to download and reinstall the firmware again, then it worked.
https://www.obdlink.com/support/ex/
Re: service procedure has been interrupted
Posted: Tue Nov 23, 2021 1:51 pm
by trmoody
Did you already have the latest version of FORScan? I'm having the same problem and have the latest version (2.3.43). Did you delete this version and just reload it and everything was fine or did you upgrade to this version? This is driving me nuts.
Re: service procedure has been interrupted
Posted: Tue Nov 23, 2021 5:19 pm
by fordsmax471
Re: service procedure has been interrupted
Posted: Fri Dec 10, 2021 5:58 am
by aspect
I'm having the same issue with 2022 maverick...are there any more up to date versions that may solve the issue?
Thanks!
