need to know BCM wire-up for module firmware update.
Posted: Wed May 14, 2025 7:40 pm
i have a godiag gt100+ and my forscan setup, i also have a dc to dc power supply to supply consistent power to the setup...
my issue is that no matter what, forscan fails at attempt to update bcm, always says vehicle conditions not met
what am i doing wrong ??
i have all the pinouts and diagrams for my 2015 fusion, and i have the 12v-15 lines on what i believe to be ignition line and the 12v30 lines connected to always hot sources like it should, all ground and all canbus are good..
i can see and read the module, but cant even change a single digit in the asbuilt programming, it fails with above mentioned info
my issue is that no matter what, forscan fails at attempt to update bcm, always says vehicle conditions not met
what am i doing wrong ??
i have all the pinouts and diagrams for my 2015 fusion, and i have the 12v-15 lines on what i believe to be ignition line and the 12v30 lines connected to always hot sources like it should, all ground and all canbus are good..
i can see and read the module, but cant even change a single digit in the asbuilt programming, it fails with above mentioned info