FORScan forum

Hello FORScan Team,

I need your help with my Ford Kuga 2022 (C2 platform).

The car does not start, and there are several configuration and communication errors between BCM, RCM, and GWM modules.

Here is what I have already done:

Verified and matched all As-Built data with Motorcraft (they are identical).

Tested two different GWM modules:

The original one does not detect HVAC and some door modules, and shows more DTCs.

The used one (same As-Built) detects more modules and works more stable.

Updated firmware for several modules (PAM, etc.).

Using FORScan v2.4.19 (Extended License), but PATS Initialization function is missing.

Current errors:

BCM:

U2100:00-8A
B1182:55-8A
C1A56:51-0A
C1A58:51-0A
B1254:51-0A
B1255:51-0A
B10DA:51-0A


RCM:

U2024:51-AF
U2101:00-AF
U2300:55-AF

Additional details:

FORScan version: 2.4.19 (Extended License)

Vehicle: Ford Kuga 2022 (C2 Platform)

Interface: ELS27

GWM: Non-original module currently used (the original causes network detection issues)

Both BCM and RCM have the correct VIN in configuration.

As-Built values are identical to Motorcraft.

Questions:

How can I enable or access PATS Initialization for this vehicle/platform (C2)?

Would an older or newer FORScan version support this?

Could re-flashing or re-initializing BCM ↔ RCM ↔ PCM help to resynchronize modules?

Any guidance on the recommended firmware update order?

Thank you very much for your time and support.
Best regards,
Vitali Zadorozhnyi

Posting in the forum for support from the FORScan team doesn't work. They don't monitor all the posts on the forum.
Go to https://forscan.org/support.html
Read through the information in the paid extended licence area. If you can't find what's needed, use the link that is for when you have another question. Here you will find an email address & details on how to find the debug data that you must attach to the email.

Hi,
Have you been able to solve the RCM problem?