Transit Connect 2012 overheating
Posted: Wed Mar 11, 2026 8:24 am
Hello,
I have a 2012 Transit Connect WF0UXXTTPUCK78122 with the engine overheating,a few years ago was made dpf off(client says).
The blower start at 120*C low speed,130*C high speed,I think is very high the point of turning on(I used a heater to check this,in the normal race I can't see any speed of blower on,except for AC on).Is possible to reprog PCM with stock software,there is a source for this?
PCM - Powertrain Control Module
Part number: AT11-12A650-BJ
Calibration level: AT11-12A650-BJ
Hardware type: SID-206 / SID_206
Software version: 2011-04-06
VIN: WF0UXXTTPUCK78122
Thank you
I have a 2012 Transit Connect WF0UXXTTPUCK78122 with the engine overheating,a few years ago was made dpf off(client says).
The blower start at 120*C low speed,130*C high speed,I think is very high the point of turning on(I used a heater to check this,in the normal race I can't see any speed of blower on,except for AC on).Is possible to reprog PCM with stock software,there is a source for this?
PCM - Powertrain Control Module
Part number: AT11-12A650-BJ
Calibration level: AT11-12A650-BJ
Hardware type: SID-206 / SID_206
Software version: 2011-04-06
VIN: WF0UXXTTPUCK78122
Thank you