FORScan forum

Anyone foud out if you can reprogram the mirrors on a 2019 f250 to auto fold with motor or of off? have folding mirrors but not auto fold but ford said they can not program it , or dont know how to?

Any solution on this? I tried pluging my ELMcongig usb adapter and only get 6-7 modules to program but not yhe modules that control the autofold mirror option .Is this normal for the 2019 model superduty?any help much appreciated .

Which module controls the auto fold option, I thought it was in the BCM.

I thought it was ddm

have you tryied in the ipc and bcm centrel config options (make sure your in engineering mode with all hidden options shown ) , may be in thier ?.

It is ddm and pdm for auto fold mirrors. As for only getting a few it should ask you to switch the elmconfig to hs I believe then it get more.
You also have to switch two wires on both mirrors. I have done most of them but not the mirrors yet the def % works also the temp. And the police and the double honk work. Have to look tonight and see if Bambi mode works.
You can put a gauge in the screen for the DEF like a gas gauge as to get prescient you have to go to the setting to read it after you have it in forscan.
2019 f250 king ranch 4x4 6.7 cc

Although this remote auto-fold ForScan mod is shown as an F150 mod, I’m trying to set up my 2017 F250 (with towing mirrors) for the auto fold mirrors on lock. It shows the same mod on the Super Duty spreadsheet, but I am just not getting it right. I swapped pins 18/19 in both pass. and driver mirror harnesses, but no luck. The wire colors for 18/19 were close but not exactly as per the F150 noted mod, but I was assuming it would be the same as the harnesses and pins in use look identical. I’ve tried both Lincoln style and regular codes in the modules but no joy.

Anyone have similar issues and resolve it??

Scott

Did you get the auto fold to work? I switched the 18 & 19 but nothing happened except one mirror goes in and the other goes out. Screwed it up.

I tried this out swapped the 18-19 pins on both sides then went to PDM and DDM and swapped the codes that are on the spreadsheet I even tried the other non install that just says enable disable and had no luck. I noticed when I only swapped one side the driver mirror acted like it wanted to fold but it did not. I ended somehow messing with the temperature setting (reset I believe the evap temperature sensor because my screen read -39 outside temperature) causing AC pump to not turn on I had to drive around for a few miles so the sensor would recalibrate itself and my AC pump started turning back on. Anyhow after all this I was unable to successfully get the auto folding. If someone gets a successful change I would appreciate some help.

i recently did the auto fold on my 2019 f350. i did the key fob where they are suppose to fold with the unlock and lock button. i switched pins 18 and 19 on both mirrors. results are mirrors will fold when the lock button on fob is pressed and when i unlock truck they will fold after i open and close the door. only thing i am trying to find out is if this mod some how messes with the spot and cargo lights as i have lost both functions. checked what fuses i am aware of and all good.