Error on FCDIM after SD Card Nav Update

[piolin49]

Hi everybody:

I've got a C-Max (2011). I've updated all modules by using IDS and SD Card Nav too. Now I've got v6 (2016) versión (the last one). Since V3 of SD Nav, when I check DTC in ForScan appear two lines. I clear them but pop up again. These are:

FCDIM U2100: 00-2F Intial Configuration Not Complete

FCDIM U2101: 00-2F Control Module Configuration Incompatible

My car is ccc configuration. I mean, FCDIM doesn't have ítem at "Program and Service". Just IPC and BCM. BCM is "main" and IPC is "backup". No more modules I can configure with ForScan.

Anybody knows how to solve?

GPS works ok. Everything works ok but I wanna know if It is posible to take out these two DTCs.

Regards

[DanMc85]

If you have IDS, try doing As-Built programming on the FCDIM if it shows up in the options.
If not may need a Sync reflash.

[piolin49]

Thank you for your answer:

I did "As Built" from ETIS for my car with IDS. Just a file VIN.xml, no option at any module (The same way as ForScan). ForScan is easier than IDS... Congratulations for ForScan Team.

I updated FCDIM too with last calibration and other modules (all of them that IDS showed me) and the page of Ford for calibration updates. Besides my car is before Sync. I mean No Sync.

People who has updated SD Card Navidation v3 and above, they get these DTCs at FCDIM module.

Any more idea?

Thank you in advance

Regards

[danY2014]

There is an option FCDIM As-Built Format in ForScan Extended license...but I do not know how to that, what data I should load and write there. Maybe this coul be the help for us. I have the same FCDIM anoying DTC U2100: 00-2F Intial Configuration Not Complete

[Txusman]

Hello, i eid the same updgrade to my focus, and had the same problem. to set the initial config, enter fcdim asbuilt config with forscan, and modify 7A5-01-01-00AE to 7A5-01-01-10BE (this is in a 2011focus, maybe other models fcdim is in anotber block)
with this i removed u2100 initial config incomplete, but not u2101 i itial config incompatible. hope this help.

[danY2014]

Thanks for response @Txusman . So if I can only see U2100 error code, your reply should be a solution? Could I damage my FCDIM with this procedure? Thanks.

[Txusman]

I think ther is no risk, i tried different numbers I found in different forums, untl I found this in a russian forum.
the last two digits are only valid if your fcdim is at 7a5 0101 addres, 10 sets intial config,and BE (last two digits) are the checksum; this change if the address of fcdim is different, and you will have to calculate it.

[danY2014]

Excellent job @Txusman! I have just successfully fixed that U2100 everlasting error! Thanks a lot.

[Txusman]

Glad it worked; can you post all of your fcdim config blocks?
I will test it to try to delete my u2101

[danY2014]

Sorry for my delay... you mean this: http://www.ford-focus.cz/forum/download ... &mode=view ? Let me know if it was useful.