Executing Service Procedure - on first read of BCM
Posted: Thu Sep 19, 2024 10:09 am
I've just purchased a vLinker USB and extended licence.
I've plugged into my Tourneo Connect, tried to "Play" the BCM configuration. Both the "AsBuilt" and other line.
In both cases, it reads modules upto 4 then stops with "Executing Service Procedure" and 0% still showing at the bottom.
I have to click "stop".
Only Tyre management options then show.
I've tried with engine on so I have higher voltage.
I've tried clearing all faults.
Any other ideas?
I've not tried to update anything at all yet.
I've plugged into my Tourneo Connect, tried to "Play" the BCM configuration. Both the "AsBuilt" and other line.
In both cases, it reads modules upto 4 then stops with "Executing Service Procedure" and 0% still showing at the bottom.
I have to click "stop".
Only Tyre management options then show.
I've tried with engine on so I have higher voltage.
I've tried clearing all faults.
Any other ideas?
I've not tried to update anything at all yet.