I’m having issues with a 2025 Mazda CX-30:
AS-Built Write:
Writing AS-Built to a brand new RCM (SAS) fails with:
“Service procedure has been interrupted”
Battery >12.5V, ignition ON, engine off.
Hardware Used: Autel MaxiFlash JVCI, ABRITES interface
License: Paid FORScan Extended
(OK) [14:59:16.694] SAS Module configuration (AS BUILT format) has been started
(OK) [14:59:18.532] Read block #1
(ERR) [14:59:43.463] Service procedure has been interrupted
(OK) [15:01:18.228] SAS Module configuration (AS BUILT format) has been started
(OK) [15:01:20.028] Read block #1
(ERR) [15:01:35.371] Service procedure has been interrupted