FORScan forum

Hello, having injector issues on original PCM, i replaced by new one.
Flash done with IDS 108 but no way to grant security without OASIS LOCKSMITH access to program smart keys (B10DA:51-0A).
Is there a way to test PATS RESET ?
Thanks helping.
Best regards.

This us what the workshop manual says.

Installation

To install, reverse the removal procedure.

NOTE: This step is only necessary when installing a new component.

Upload the module information from the diagnostic tool using the Programmable Modules Installation routine.
Refer to: Module Configuration - System Operation and Component Description (418-01 Module Configuration, Description and Operation).

Carry out the Parameter Reset procedure.
Refer to: Anti-Theft Key Programming - Scan Tool (419-01B Passive Anti-Theft System (PATS), General Procedures).

Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.

Hi and thanks helping slippy1990 but i can't carry out the Parameter Reset procedure cause my aftermarket IDS account not allow access security PATS ONLINE for new Ford models.
It is for that i thought that was a way using FORScan to allow this "RESET".
Best regards.
;o)

Hello buddy, how did you resolve this b10da error problem ? I have 2016 explorer that I have replace bcm but can’t perform
Successful parameter reset

I dont think "parameter reset" is possible with Forscan. How did you program your existing keys to the new BCM?