- DLC-Data-Link-16-Pin-Out.jpg (204.79 KiB) Viewed 23911 times
If it is OBDLink EX, did you visit the support page for the correct drivers?
Did you look for a firmware update?
Post your results.
How to setup ELM327 USB driver in Mac OX under CrossOver
-
Ecmbuster
- Posts: 2433
- Joined: Sun Mar 15, 2015 4:08 am
- Vehicle: Subaru, Volvo Bertone and two Motorcycles
- Location: On a spinning rock
Re: How to setup ELM327 USB driver in Mac OX under CrossOver
Did you try to see if PIN 16 has battery power?
OBD2EX or OBDLink EX ??? which one?
If it is OBDLink EX, did you visit the support page for the correct drivers?
Did you look for a firmware update?
Post your results.
If it is OBDLink EX, did you visit the support page for the correct drivers?
Did you look for a firmware update?
Post your results.
Do not ask for help in PM. Use the forum to ask and answer questions! There's a special place for NOT following up!
Re: How to setup ELM327 USB driver in Mac OX under CrossOver
Is the procedure and program compatible with macbook with M1 processor? Or only with intel series processors? Thank you,