FORScan forum

We've been discussing this on a Yamaha motorcycle forum and technically, separate load resistors are not required if you can find LED turn signal bulbs that fit and have integral resistors. Here are a couple examples that fit our Yamahas , a little searching may reveal something that works ...

It is not uncommon in the older F150 to unplug the BCM, especially following a battery replacemnt. This is not harmful in any way and allows the battery to be charged to full potential so accessory and shutoff power can be used longer.

I've been wondering since 2013. Haven't found a way yet!

Might be, if you can figure out which parameter needs to be changed. My truck is older so finding a table of them was no problem. I explained my process here, at the bottom of page 1 -> viewtopic.php?f=5&t=16100&hilit=parameter

Here in the USA, with our pickup trucks, we often unplug the BMS. When we've replaced the battery or add large electrical loads the BMS doesn't work properly and allows the battery to discharge unnecessarily or not charge properly. We have found that this affects nothing more. Below is a picture of ...

YMMV of course but the available window and door lock changes for my 2013 are shown in my owner's manual. Neither are done via Forscan nor the dash display unit.

It looks like there's a clear description in your owners manual for "Resetting the One-Touch Close". Did you do the procedure?

Check your owners manual, that's where info for my truck is, it's called "Restoring the One-Touch Up Functionality".

Changing my F150 door lock control schemes are listed in my owners manual. Have you looked in your manual?

bbfly 55502, usb connected. Always works with my Win11 laptop. http://bbflyobd.com/products/show/564.html#/

https://www.amazon.com/dp/B01N18TOFB?ref=myi_title_dp