ReFlash dead Module with Forscan 2.40???

[ddg71]

if this still does not work, install the files separately

1.
...21..
...19..
...82..

do not turn the ignition off

2.
...21..
...24..

do not turn the ignition off

3.
...21..
...81..

Thanks a lot for the answer, one more question please, how can I deactivate "System Off Battery Saver" from sync ? thank you

[ddg71]

if this still does not work, install the files separately

1.
...21..
...19..
...82..

do not turn the ignition off

2.
...21..
...24..

do not turn the ignition off

3.
...21..
...81..

I finally managed to separate modules I upload as you said, thank you very much

[rich935]

How do you install the files separately?

[Snowball]

you select custom at the top and then only the secondary boot loader (sbl) and the file you want to write separately. Leave all the other options blank.

[rich935]

you select custom at the top and then only the secondary boot loader (sbl) and the file you want to write separately. Leave all the other options blank.

Is it too much trouble to ask for a screenshot if you can. Thanks.

[ddg71]

you select custom at the top and then only the secondary boot loader (sbl) and the file you want to write separately. Leave all the other options blank.

exact !!!

[rmorriso86]

so i have the same problem with the ipma it upload them all then fails on the last one tried doing just the last one as a custom still a no go goes to 97% then shows a failure? Any other ideas? running 2.4.3 test20200917

[rmorriso86]

this is a image

[fordsmax471]

this is a image

https://www.forscan.org/forum/viewtopic ... 444#p55444