FORScan forum

Change it to this:
760-03-03 -> XXXX-XX02-2B

Anyway, 99% you will get the error with the modes. As I said PSCM is involved in that... unless there is a difference between diesel and petrol

I was already aware of how to unlock modes by modifing the ABS config, but in my case when i tried that (early 2021), after moving the car few meters a DM error appear and mode is reset to Normal.

This happened on a Fiesta MK8 1.0EB 2020 (Gen 3). Stock modes were Sport/Normal/Eco

I added Slippery ...

yeah... i noticed too late

fordsmax471 wrote: Tue Nov 26, 2019 6:13 pm Els27 v3 not work whit stn5.0.0 firmware, work only whit 4.1.1

Is there any way to downgrade an ELS v3 updated to firmware 5.x?

Hi guys, anyeone tried update the IPMA calibration of the camera A* to a calibration used on B* or C*? If the hw is the same, and the difference is just the calibration software, this may avoid IPMA replacment.

edit:
Just did a bit of analysis and memory area are the same across all calibrations ...

As far as i know, you need a DAB Enabled antenna

the cruise control harness in the steering wheel is different compared to the harness of a steering wheel without cc

Hi guys i have exatly the same problem

Just installed a Cruise Control + ASL on a MK3.5 PETROL engine and it worked flawlessly. Steps were:
change the cable, install the CC buttons and enable CC and ASL in BCM using focccus.

Now, i did EXACTLY the same proceure as above with a MK3.5 GASOLINE ...